LB330 Parking Barrier User Manual
P a g e | 11 Copyright©2022 ZKTECO CO., LTD. All rights reserved.
5 Installation Procedure
Installation Precautions
1. Install the parking barrier on a flat surface. A cement foundation is required before
installation if the ground is not solid and flat.
2. It is possible to reduce the length of the boom, but it cannot be increased. After the boom
has been cut, it is important to set the spring balance again to achieve a new balance. The
bottom of the spring contains two plastic nuts designed to adjust the new balance.
3. When the barrier is powered on, do not change the wire connection inside.
4. Connect the GND to the cabinet to ensure protection.
Tools Preparation
Make sure you have all the tools that you will need to do the job. The following is a list of
tools that are required:
Impact Drill
Adjustable Wrench
Hammer
Needle-nose Pliers
Hexagon Wrench (Allen Key)
Screwdriver, etc.
To Next Page
Loading...
Need help?
General
