Detection Management Settings
Click on System Detection Management enter the setting interface > [ ] > [ ] to .
13
❷
When the Allow unregistered people to access is enabled, optionally, set Enable
capture of unregistered person to save the temperature data.
❶
You can set the value of High temperature alarm threshold, and enable the
Temperature over the range; access denied and the Trigger external alarm, the
device will send an alarm prompt when the temperature of the user detected
exceeds this value, meanwhile the user will be forbidden to access, as shown in the
following figure. The method of enabling Mask detection is the same.
Temp. Unit ℃
Temperature measurement distance Far
Detection Management
Display Body Temperature
Enable mask detection
Deny access without mask
Allow unregistered people to access
Enable capture of unregistered person
Trigger external alarm
Clear external alarm
Exter alarm delay(s) 255
Firmware update
Display Thermodynamics Figure
Main Menu
User Mgt.
User Role
COMM.
System
Data Mgt.Personalize Attendance
Search
Autotest
System Info
Access Control
L
Date Time
Access Logs Setting
Face
Fingerprint
Palm Parameter
Reset
Detection Management
System
37.30
0.00
Enable temperature screening with infrared
High temperature alarm threshold
Temperature over the range; access denied
Temperature deviation correction
Temp. Unit
Temperature measurement distance
Display Thermodynamics Figure
Display Body Temperature
Enable mask detection
Deny access without mask
Allow unregistered people to access
Enable capture of unregistered person
Detection Management
Far
O
C
O
C
08:50
Successfully verified.
Name:Mike
User ID:4835
Verify:Face
Normal temperature
O
Temp.: 36.6 C
Mask Detected
08:50
Failed to verify.
Verify:Face
User ID:4835
Without mask
High body temperature
O
Temp.: 38.6 C
To Next Page
Loading...
Need help?
General
