ZMC420SCAN Motion Controller
Chapter One Controller Introduction
ZMC is the abbreviation of the network motion controller model introduced
by the positive motion technology.
ZMC420SCAN bus controller supports ECAT / RTEX bus connection,
supports up to 20 axis motion control, supports linear interpolation,
arbitrary arc interpolation, space arc, spiral interpolation,
electronic cam, electronic gear, synchronous follow, virtual axis
settings Etc .; using optimized network communication protocol can
realize real-time motion control.
ZMC420SCAN bus controller supports mixed interpolation
of pulse axis / bus axis / galvanometer axis. A single
computer supports up to 256 ZMC controllers
simultaneously linked.
1.1
Connection configuration
Typical connection configuration diagram
To Next Page
Loading...
Need help?
General