Zodiac FloPro e3 - Product Usage; Operating Principle and Interface; Basic Operation

8
❸ Use
3.1 I Opera ng principle
The fi ltra on pump forms the core of the pool and is essen al as it is used to circulate water through the pool’s diff erent
components, in par cular the fi lter.
Its motor drives the turbine in rota on, which drives the water. The large strainer of the pre- fi lter collects major debris
to prevent the fi lter from becoming clogged too quickly or from becoming damaged.
3.2 I User interface presenta on
Symbol Designa on
Key
"ECO" speed ac va on
Speed reduc on in se ng mode
LED
Flashing: in priming mode (approx. 2 minutes on start-up)
Fixed: speed in opera on
Key
"CLEAN" speed ac va on
Recording of the current se ng (press for 10 seconds)
LED
Flashing: in priming mode (approx. 2 minutes on start-up)
Fixed: speed in opera on
Key
"BOOST" speed ac va on
Speed increase in se ng mode
LED
Flashing: in priming mode (approx. 2 minutes on start-up)
Fixed: speed in opera on
Key Shutdown of the speed during opera on
LED
Flashing: pump stopped, powered up
Fixed: pump in opera on
LED The number of fl ashes indicates the error in progress
3.3 I Opera on
• To prevent against any risk of explosion that may cause material damage, serious injury or
even death, make sure that the hydraulic circuit is free of any debris or blockage and is not
subject to excessive pressure.
• Never run the pump "dry" as this may damage it.
• The pre- fi lter strainer cover must be closed by hand (do not use any tools).
• Check that the hydraulic connec ons are correctly  ghtened.
• Check that the pump is stable and level.
• The hydraulic circuit must be bled and not contain any foreign bodies.
• The pump pre- fi lter strainer cover must be correctly closed (by hand) and its gasket clean and in place.
• Check that the valves are open.
• Start up the pump by ac va ng a speed. The pump always starts in "priming" mode (2850 rpm for approx. 2 minutes).
• The pump is self-priming. However, you are strongly recommended to fi ll the pre- fi lter strainer with water before
star ng it up for the fi rst  me to facilitate the procedure.
• The pump has a priming capacity up to 3 metres above the swimming pool water level and at sea level eleva on (if
the hydraulic circuit is perfectly sealed).
• Bleed any air present in the fi ltra on circuit using the bleed normally present on the fi lter (refer to the swimming pool
fi lter's manual).
• Check that there are no leaks on the hydraulic circuit.