Zodiac MS FILTER D470 - I Assembling the Filter

6
2.2 I Assembling the lter
2.2.1 Assembling the pressure gauge and air release
• Only ghten parts by hand.
• Screw the T-connector provided ( ) into the central orice ( ) of the translucent cap. Use the gasket provided
(
) to seal. Do not use Teon tape.
• Screw the air release ( ) onto the large threaded orice of the T-connector ( ).
Tip: installing the bleed screw
The bleed screw already contains its own seal; do not use Teon tape to seal.
• Screw the pressure gauge ( ) onto the small threaded orice of the T-connector ( ).
Tip: installing the pressure gauge
Teon tape (not included) may be required to improve the sealing of the pressure gauge on the T-connector.
: T-connector
: Bleed screw
: Pressure gauge
: Central orice
: Gasket
EN