Zodiac MX6 - I Replacing the Tracks; I Storage and Winterizing

14
4.4 I Replacing the tracks
• Lay the cleaner on one side.
• Starng with one of the wheels, pull the inside of the track to separate it from the wheel (see image ). Then remove
the track from the cleaner.
• To install the new track, posion the inside of the track on the small wheel's grooves and on one of the large wheels.
• Stretch the track around the second wheel, (see image ). Press down on the track to posion it correctly on the
wheel grooves. Make sure that the track passes under the guide.
4.5 I Storage and winterizing
• For winterizing, drain o all the water from the cleaner (damage caused by frost is not covered by the warranty).
• Clean the whole device and the hoses in clean water then leave to dry.
• Store the device in a dry place which is protected from freezing condions. Store the cleaner on its side or back to
avoid damage to turbine (voir image ).
• Remove all the connectors and adaptors from the sucon line or the skimmer.
Tip: Preserve the condion of the hoses during storage
When the cleaner is stored away, even for short periods, avoid rolling the hoses: they may take on a shape
which may harm the cleaner's performances.