Zodiac MX6 - Express Warranty and Guarantees; Express Warranty; Product Warranty Registration; How to Make a Warranty Claim

9
❸ Use
3.1 I Operang principle
The hydraulic cleaners connect to the ltraon system (either to a sucon line or a skimmer); they use the ltraon
pump’s energy to move around the pool. The wall climbing capacity varies according to the shape of the pool and the
available water ow.
The debris is sucked in by the cleaner and captured in the ltraon pump's lter basket or in the Cyclonic
TM
Leaf Catcher
(accessory included or available as an opon depending on the model).
3.2 I Pool preparaon
• This product is intended to be used in pools which are permanently installed. Do not use it in
pools which may be dismantled. A permanent pool is built into the ground or on the ground
and cannot be easily dismantled and stored.
• The device must operate in pool water with the following quality:
Water temperature Between 15°C and 35°C
pH Between 6.8 and 7.6
Chlorine < 3 mg/ l
• When the pool is dirty, especially when rst installing your cleaner, remove the largest debris using a telescopic pole
and net prior to installing the cleaner.
• Remove any thermometers, toys and other objects that might damage the device.
• Aer adding chemical products to the water, wait at least 4 hours before pung the cleaner into the water.
• Make sure that the ltraon and the skimmer baskets are clean.
• Aim the pool return lines downward if adjustable.
• Close the pool’s main drain line.
• Turn o the ltraon pump o.
3.3 I Operang
• To avoid serious injury, make sure the ltraon pump is turned o.
• Do not expose your hair, loose clothing, jewellery, etc. to the open end of the hose.
3.3.1 Connecng the ow regulator valve and immersing the cleaner
• Connect the ow regulator valve to the hose (see image ).
• Immerse the cleaner so that it lls up with water.
• When there are no more air bubbles escaping from the cleaner, connect the hose by inserng the ow regulator valve
onto the cleaner (see image ).
• Let the cleaner descends to the boom of the pool.
3.3.2 Filling the hose assembly
• Disconnect the hose assembly from the sucon line or skimmer temporarily.
• Turn on the ltraon pump.
• Fill the Hose assembly with water by placing the open end in front of a pool return line unl it is lled.
• Turn o the ltraon pump and connect the Hose assembly to the dedicated sucon line or skimmer.
• Turn on the ltraon pump on to acvate the pool cleaner.
EN