Zodiac MX8 - Installation; Prepare the Pool; Assemble and Connect the Hose; Assemble Hose Sections

Page 4
ENGLISH
Zodiac
®
MX8
™
Pool Cleaner
|
Owner’s Manual
Installation
Prepare the Pool
1. Turnoffthepoolfilterpump.
2. Manuallyvacuumthepool,andmakesurethepoolfilterandpumpbasketareclean.
3. Closethepoolmaindrainline.
4. Aimthereturnlinefittingsdown.
Assemble and Connect the Hose
WARNING
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUS INJURY
OR DEATH. Ensurethatyourvacuumsuctionttingsinstalledinyourpoolforconnectionofyoursuction-side
poolcleanerarecertiedasbeingcompliantwithapplicablesafetystandardssuchasIAPMOSPS4.Donot
blockthesuctionttingswithanypartoryourbody.Donotexposeyourhair,looseclothing,jewelry,etc.toany
suctionoutletttingsorhoseendsinthepool/spa.
Assemble hose sections:
 Pushandtwisttheconnectoroneachhosesectionuntiltheylockintopositionwithclickingsound.Hose
cuffshavethree(3)connectionpositions.Anyofthethree(3)positionsaresufficientforanair-tightseal.
x 11
Figure 2