Zodiac TRi - Information Before Installation; Technical Specifications; Preparing the Pool: Water Balance

3
EN
1. Information before installing
1.1 Contents
Power pack Cell Flow controller kit Bag of accessories
1.2 Technical specifications
Power supply voltage 230Vac-50Hz
Electric power
195W
Protec on index IP23
Box size (l x h x d) 31 x 33 x 11 cm
Cell size (L x d) 30 x 10 cm
Weight (box + cell) 7 Kg
Minimum Maximum
Flow through the cell 5m³/h 18m³/h
Pressure in the cell / 2.75 bars
Opera ng water temperature 5 °C 40 °C
2. Installation
2.1 Preparing the pool: water balance
The appliance is designed to disinfect pool water using its salt water chlorina on func on.
It is essen al that the pool water balance is controlled and adjusted before installing the appliance. Making sure that the
pool water balance is correct from the very start will reduce the likelihood of encountering problems on the fi rst days of
opera on or during the season the pool is in use.
Even though it is an autonomous system, it is essen al to regularly analyse the water to check the water balance
parameters.
Unit
Recommended
values
To increase To reduce
Test frequency
(in the season)
pH / 7.2 – 7.4
Add pH+ or use
automa c regula on
Add pH- or use
automa c regula on
Weekly
Free
chlorine
mg/L or
ppm
0.5 – 2
Increase the appliance’s
chlorine produc on or
use the Boost mode
Reduce chlorine
produc on
Weekly
TAC
(alkalinity or
buff ering power)
°f (ppm)
8 – 15
(80 – 150)
Add alkaline corrector
(Alca+ or TAC+)
Add hydrochloric acid Monthly