4.4.5 Repeater
î Repeater-SSID: The name for your repeater.
î IAPP: Enable it to allow wireless station roaming between IAPP enabled access
points within the same wireless LAN.
A repeater is placed between an AP and a client to extend the distance between the two
WLAN devices. Functioning as a repeater, ZEW3003 connects to both a client card as an
AP and to another AP. In typical repeater applications, APs connecting to other APs
equipped with WDS functionality must also support WDS.
Figure below shows an example of a Repeater network with two ZEW3003 Repeaters
connected to a ZEW3003 (AP mode), with each Repeater allowing wireless clients to
associate.
Note: Repeater mode only can be enabled on two or more ZEW3003 networking environment.
To Next Page
Loading...
Need help?
General