Configuration from Embedded Web Server
5 - 23
TCP/IP Setup
1. Click Setup, it then appears the sub-menu.
2. Click TCP/IP, it then as shown in the following picture.
DHCP/BOOTP: This option allows you to select DHCP/
BOOTP option. If there is a
DHCP/BOOTP server on your network.
This option allows the print server to
obtain IP-related settings automatically
from your DHCP server.
IP Address: This option allows you to input IP address
from the print server. The IP address must
meet the IP addressing requirements of the
network segment.
To Next Page
Loading...
