TCP/IP LPR Port Printing Installation
7 - 12
At the tftp prompt, type “get config.txt” to retrieve the Print
Server‘s configuration file. For example:
tftp > get config.txt
5. Quit from tftp, and then use your editor to modify the
“05 BoxIPAddress” field in the config.txt file from
0.0.0.0 to the IP address you specify in Step 2.
6. (Optional) Modify the "06 Gateway" field from 0.0.0.0
to your gateway's IP address.
7. (Optional) Modify the "07 SubnetMask" field from
0.0.0.0 to the subnet mask.
8. When done, save the new config.txt.
9. Type “tftp < Print server‘s IP address>”
At the tftp prompt, type “put config.txt” to save the new
configuration file back to the Print Server.
For example:
tftp > put config.txt
10. Type “mkdev rlp”
After this step, the Remote Printer Configuration appears.
Answer the questions as follows:
a. Do you want to install or remove printing (i/r/q) ?
[q] : -----> i
b. Do you wish to change the printer description
file /etc/printcap (y/n) [n] ? ---------> y
c. Enter information for remote printers or local
printers accepting remote printing requests
Please enter the printer name (q to quit): --->printer-1
To Next Page
Loading...
