8 On the 3G router, when the program displays a message that the process succeeded,
click SET to keep the router from receiving new configuration parameters from another
WPS Registrar.
9 Click Save to save the configuration.
Configuring Wireless Security Manually
WPA2/WPA Configuration
Wi-Fi Protected Access (WPA) is an encryption method that offers a stronger security
standard than WEP.
Important! If you choose to configure your router using either WPA2 or WPA
encryption, then you must configure all devices on your wireless network with the
same WPA encryption method and shared key.
1 To configure WPA2 or WPA encryption, select Advanced > Basic Settings > Wireless to open
the Wireless Setting page.
2 Select or enter values in the following fields:
Field Entry
Wireless Module Accept the default, Enable. Click the Disable checkbox only if you do
not want wireless clients to access your network.
Network ID (SSID)
Refers to the Service Set Identifier for your device. By default, the
SSID for the 3G Wireless-N Router is
Zoom. You can change the
SSID to a name of your choice. The SSID can be up to 32
alphanumeric characters. If you change the name, make sure that all
devices on your network use the new SSID as the access point.
SSID Broadcast
To hide your network's SSID name, which disables automatic
broadcasting of the SSID and makes the wireless access point (your
router) invisible to wireless clients on the network, click the Disable
radio button.
Chapter 4: Wireless and Wireless Security Setup 27
To Next Page
Loading...
