2 3
DYNAMICS / FILTER
Comp This compressor in the style of the MXR Dyna Comp.
Parameter1 Parameter2 Parameter3
Page01
Sense 0–10 P Tone 0–10 Level 0–150 P
Adjusts the compressor sensitivity. Adjusts the tone. Adjusts the output level.
Page02
ATTCK Slow, Fast
Sets compressor attack speed to
Fast or Slow.
160 Comp This compressor is in the style of the dbx 160A.
Parameter1 Parameter2 Parameter3
Page01
THRSH -60 – 0 Ratio 1.0 – 10.0 Gain 0 – 20
Adjusts the threshold that determines
when the effect is activated.
Adjusts the compression ratio. Adjusts the gain after compression.
Page02
Knee Hard, Soft Level 0 – 150 P
Sets the type of knee. Adjusts the output level.
SlowATTCK This effect slows the attack of each note, resulting in a violin-like performance.
Parameter1 Parameter2 Parameter3
Page01
Time 1–50 P Curve 0–10 P Level 0–150 P
Adjusts the attack time.
Set the curve of volume change during
attack.
Adjusts the output level.
Page02
ZNR
ZOOM's unique noise reduction cuts noise during pauses in playing without affecting the tone.
Parameter1 Parameter2 Parameter3
Page01
THRSH 1–25 P DETCT GtrIn, EfxIn Level 0–150 P
Adjusts the effect sensitivity. Sets control signal detection level. Adjusts the output level.
Page02
NoiseGate This is a noise gate that cuts the sound during playing pauses.
Parameter1 Parameter2 Parameter3
Page01
THRSH 1–25 P Level 0–150 P
Adjusts the effect sensitivity. Adjusts the output level.
Page02
GraphicEQ This unit has a 6 band equalizer.
Parameter1 Parameter2 Parameter3
Page01
160Hz -12–12 400Hz -12–12 800Hz -12–12
Boosts or cuts the low (160 Hz) frequency
band.
Boosts or cuts the low-middle (400
Hz) frequency band.
Boosts or cuts the middle (800 Hz)
frequency band.
Page02
3.2kHz -12–12 6.4kHz -12–12 12kHz -12–12
Boosts or cuts the high (3.2 kHz)
frequency band.
Boosts or cuts the extremely high
(6.4 kHz) frequency band.
Boosts or cuts the harmonics (12
kHz) frequency band.
Page03
Level 0–150 P
Adjusts the output level.
ParaEQ This is a 2-band parametric equalizer.
Parameter1 Parameter2 Parameter3
Page01
Freq1 20Hz–20kHz Q1
0.5, 1, 2, 4, 8, 16
Gain1 -12–12
Adjusts center frequency of EQ1. Adjusts EQ1 Q. Adjusts EQ1 gain.
Page02
Freq2 20Hz–20kHz Q2
0.5, 1, 2, 4, 8, 16
Gain2 -12–12
Adjusts center frequency of EQ2. Adjusts EQ2 Q. Adjusts EQ2 gain.
Page03
Level 0–150 P
Adjusts the output level.