Preparation Installing an SD card
05
H2n Handy Recorder
Installing an SD card
1.
After turning the power OFF, open the SD card slot cover.
2.
Insert the card into the slot.
To remove a card, push it further into
the slot and then pull it out.
HINT
Built-in memory
· The built-in memory only keeps the most recent recording.
· The recording format is fixed at 96kbps MP3.
· It cannot be used to record in 4ch surround or MS-RAW modes.
· Recording time is limited to 1 minute.
· Recordings saved to the built-in memory cannot be copied to an SD card or a computer.
NOTE
· Be sure to insert the SD card correctly, using the cut-off corner illustration next to the
slot as a guide.
· The built-in memory will be used if no SD card is in the recorder.
· Before using SD cards that have just been purchased or that have been formatted on a
computer, they must be formatted by the
. To format an SD card, use MENU >
SD CARD > FORMAT.
To Next Page
Loading...
