26 27
COMPRESSOR
This compressor in the style of the MXR Dyna Comp.
SENSE Adjusts the sensitivity of the effect. 0 - 10
ATTCK Sets compressor attack speed to Fast or Slow. SLOW, FAST
TONE Adjusts the tone. 0 - 10
VOL Adjusts the volume. 0 - 100
RACK
COMPRESSOR
This compressor allows more detailed adjustment than Comp.
THRSH Sets the level that activates the compressor. 0 - 50
RATIO Adjusts the compression ratio. 1 - 10
ATTCK Sets compressor attack speed 1 - 10
VOL Adjusts the volume. 0 - 100
GRAY
COMPRESSOR
This models a ROSS Compressor.
Added parameters allow you to adjust the tone.
SUSTN Adjusts the sustain. 0 - 100
LO Adjusts volume of low frequencies. 0 - 100
HI Adjusts volume of high frequencies. 0 - 100
VOL Adjusts the volume. 0 - 100
OPTICAL
COMPRESSOR
This is an optical compressor.
DRIVE Adjusts the depth of the compression. 0 - 10
LO Adjusts volume of low frequencies. 0 - 100
HI Adjusts volume of high frequencies. 0 - 100
VOL Adjusts the volume. 0 - 100
160
COMPRESSOR
This compressor is in the style of the dbx 160A.
THRSHLD Adjusts the threshold that determines when the effect is activated. -60 - 0
RATIO Adjusts the compression ratio. 1.0 - 10.0
KNEE Sets the type of knee. SOFT, HARD
VOL Adjusts the volume. 0 - 100
DUAL
COMPRESSOR
This is a compressor which allows separate settings for the low frequency and high
frequency range.
FREQ Adjusts the crossover point between the high frequency and low frequency range.
300Hz -
1.5kHz
LOCOMP Adjusts the compression depth in the low frequency range. 0 - 50
HICOMP Adjusts the compression depth in the high frequency range. 0 - 50
VOL Adjusts the volume. 0 - 100
MULTIBAND
COMPRESSOR
This is a simulation of the MultiComp (MODE:MB).
COMP Adjusts the depth of the compression. 0 - 100
LOTHR Adjusts the threshold that triggers the low-frequency effect. 0 - 100
HITHR Adjusts the threshold that triggers the high-frequency effect. 0 - 100
VOL Adjusts the volume. 0 - 100
LIMITER This is a limiter that suppresses signal peaks above a certain reference level.
THRSH Adjusts the effect sensitivity. 0 - 50
RATIO Adjusts the compression ratio. 1 - 10
REL This is a limiter that suppresses signal peaks above a certain reference level. 1 - 10
VOL Adjusts the volume. 0 - 100
DYNAMICS
To Next Page
Loading...
