Zoom MS-70CDR+ - Delay Effects Guide; Basic and Tape Echo Delays

10 11
DELAY This long delay has a maximum length of 4000 mS.
TIME Sets the delay time. 1 - 4000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
HIDMP Adjusts the treble attenuation of the delay sound. 0 - 10
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
ANALOG
DELAY
This analog delay simulation has a long delay with a maximum length of 4000 mS.
TIME Sets the delay time. 1 - 4000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
HIDMP Adjusts the treble attenuation of the delay sound. 0 - 10
VOL Adjusts the volume. 0 - 100
P-P Sets delay output to mono or ping-pong. MONO, P-P
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off
OFF, ON
TAPE ECHO
This effect simulates a tape echo. Changing the "Time" parameter changes the pitch of the
echoes.
TIME Sets the delay time. 1 - 2000
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
HIDMP Adjusts the treble attenuation of the delay sound. 0 - 10
VOL Adjusts the volume. 0 - 100
TAIL
When ON, effect sound continues even after effect is turned off. When OFF, effect sound stops
right when effect is turned off.
OFF, ON
TAPE ECHO 3 This tape echo effect models the Maestro Echoplex EP-3.
TIME Sets the delay time. 10 - 2900
MODE
Sets the delay time range.
When metronome is chosen, the delay time is synchronized to the tempo.
Short,
Long,
REPEAT Adjusts the number of repeats. 0 - 100
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
GAIN Adjusts the gain. 0 - 100
HI Adjusts volume of high frequencies. 0 - 100
LO Adjusts volume of low frequencies. 0 - 100
VOL Adjusts the volume. 0 - 100
P-AMP
Sets whether the TapeEcho3 preamp affects the tone when the echo effect is off. When OFF,
the input sound is output without being changed. When ON, the preamp affects the tone.
OFF, ON
DELAY