4 5
CHORUS
FIVE
This chorus is a model of the BOSS CE-5.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 0 - 100
OUTPUT
Sets output to mono or stereo. When stereo, effect sound is output from L channel and
unchanged input sound is output from R channel.
MONO,
STEREO
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 120
LO Adjusts volume of low frequencies. 0 - 100
HI Adjusts volume of high frequencies. 0 - 100
BASS
CHORUS
You can cut the low frequencies of this bass chorus effect sound.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
LOCUT Specifies the low-range cutoff point for the effect sound.
OFF -
800Hz
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
PRE DLY Turns pre-delay OFF or ON. OFF, ON
VOL Adjusts the volume. 0 - 100
ENSEMBLE
CHORUS
Ensemble This is a chorus ensemble that features three-dimensional movement.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
TONE Adjusts the tone. 0 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
VOL Adjusts the volume. 0 - 100
BASS
ENSEMBLE
CHORUS
This bass chorus ensemble features a sense of three-dimensional movement.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
TONE Adjusts the tone. 0 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
VOL Adjusts the volume. 0 - 100
STEREO
CHORUS
This is a stereo chorus with a clear tone.
DEPTH Sets the depth of the modulation. 0 - 100
RATE Sets the speed of the modulation. 1 - 50
TONE Adjusts the tone. 0 - 10
MIX Adjusts the amount of effected sound that is mixed with the original sound. 0 - 100
VOL Adjusts the volume. 0 - 100
BEND
CHORUS
This effect provides pitch bending that uses the input signal as trigger and processes each
note separately.
MODE Sets direction of pitch bend. UP, DOWN
DEPTH Sets the depth of the modulation. 0 - 100
TIME Sets time before effect starts. 0 - 50
BAL Adjusts the balance between original and effect sounds. 0 - 100
TONE Adjusts the tone. 0 - 10
MODULATION
To Next Page
Loading...
