©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
25
17. Feed the material into the extruder through the material endstop and the material guide.
18. To calibrate the platform, select Tools, next Platform, and Calibrate from the menu. Follow the instructions
displayed on the screen.
TOOLS
HEAT PLATFORM
CALIBRATE
MOVE PLATFORM
TOOLS
MATERIAL
HEAT EXTRUDER
RUN FAN TEST
Z-ULTRAT
PLATFORM
To Next Page
Loading...
