©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
45
The following tables present maintenance and repair guidelines connected with each sec-
tion of Zortrax 3D printer, together with specific check points, necessary activities and
their frequency.
Activity Frequency Solutions to the problems Necessary accessories
Cleaning the machine,
its interior and sur-
roundings, especially
the bottom plate under
the platform
Before each
printing
The user is responsible for
keeping the machine clean. To
remove material remains from
the interior of the device, use a
vacuum cleaner or compressed
air
- a vacuum cleaner,
- cleaning products
with a high evapora-
tion rate
Cleaning the mother-
board and the power
supply unit from dust
using compressed air
Every 300
working
hours
Unscrew the bottom plate
and use compressed air to
remove dust
- a 2.5 Allen key
- compressed air
1. Main
Lack of proper care of the machine can cause inevident damage or improper operation of the drive units
To Next Page
Loading...
