©2018, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
46
2. Hotend
Activity Frequency
Checking if the hotend and the nozzle are
not clogged
Before each printing
Cleaning the nozzle After nishing one spool of material
Checking if the screws that secure the
heater and thermocouple are tightened
Every 300 working hours
Lack of proper care of the machine can cause inevident damage or improper operation of the drive units
To Next Page
Loading...
