ZOTAC ZBOX nano
Using your ZOTAC ZBOX nano
Conguring wireless connection
Please follow the instructions below to connect to a wireless network:
1. Double-click the wireless network icon (pic) in the notication
area.
2. Select the wireless network you want to connect to from the
list and click Connect.
3. After connection is established, you will see “Connected.”
Note 1: For security concerns, Do NOT connect to an unsecured network,
otherwise, the transmitted information without encryption might be visible to
others.
Note 2: Enter the network security key if necessary.
Conguring wired connection
Using a static IP
1. Right-click the network icon in the
notication area and select “Open
Network Connections”.
2. Right-click “Local Area Connection” and
select “Properties”.
3. Highlight “Internet Protocol (TCP/IP)”
and click “Properties”.
4. Select “Use the following IP address”.
5. Enter your IP address, subnet mask and
Default gateway.
6. Enter the preferred DNS server address if necessary.
7. After entering all of the related values, click “OK” to nish the conguration.
Note: If you want to use USB charger for iPhone/iPad, please install the driver
at X:\Utility\Software\Usb Charger\setup.exe (X: your driver disk letter).
Click the icon to review the Page 2 of the driver DVD:
• E-SATA Controller
Each driver must be installed individually
to ensure proper operation of the
ZOTAC ZBOX nano.
3. Select the driver you want to install.
The driver installer should launch.
4. Follow the onscreen instructions for the
selected driver to install.
5. Restart the system.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
