Zte MF60 - Getting Started; Device Appearance

Indicators and Their Meaning
Network Type
“3G” (High Speed), HSPA+/ WCDMA
“E” (Mid Speed), EDGE
“2G”(Low Speed), GPRS/GSM
Signal Strength
5 bars is best. If there is no signal, only the antenna
shows.
Baery Life Remaining
4 bars is a full charge.
Flashes when charging.
Carrier Name
Try reseng the device when you see “Limited service”
(See page 8)
Connecon Status
Try troubleshoong the device when you see
“Disconnected” (See page 11)
Auto/Manual Connect
“A” indicates it will automacally connect to a
network when receiving a signal.
“M” indicates that you must manually connect to a
network. (See page 8)
Number of Wi-Fi Devices Connected
Indicates number of devices connected to the mobile
hotspot. When “0” is shown, your device (computer,
tablet, smartphone, etc.) is not connected to the
hotspot via Wi-Fi.
3
3G
AT&T
Connected
M
A
1
Network Type
Signal Strength
Baery Life Remaining
Carrier Name
Connecon Status
Auto/Manual Connect
Number of Wi-Fi
Devices Connected