• Always On: The device will automatically connect to WAN when it is powered on.
• Manual: Connect to the Internet manually.
Click Apply to confirm your configuration.
Usage of WPS
If your client device supports WPS, you need not to input the password manually after WPS has
been available. Please do the following:
1. Start up your device.
2. Launch the client device connected to your device.
3. Enable the WPS function of your device.
4. Enable the WPS function of the client.
Notes:
For the detailed operations about the client, please refer to the client’s instruction.
Logout
Select Logout, a pop-up window will appear as the following figure shown:
Click OK to logout the web page.
Disconnecting from the Internet
1. Select Disconnect Internet from WAN Connection page.
2. Click Apply to disconnect from the Internet.
Notes:
Turn off the device can also terminate Internet connection.
Sleep Mode
When you enable the Wi-Fi function and use the battery to supply power to the device, once no
user connects to the device within 10 minutes or you press the WPS button, the device will enter
the sleep mode，and the LED screen will be turned off. In the sleep mode, the Wi-Fi function will
To Next Page
Loading...
