NOTE:
Refer to your Wi-Fi-enabled client device manual for further details on how to search for wireless networks. If
you use a computer, you need to set your computer to obtain an IP address automatically.
3. Select the Wi-Fi name (SSID) of your device, and click Connect.
4. Enter the Wi-Fi password if necessary, and click OK.
NOTE:
Refer to the chapter Getting to Know the Wi-Fi SSID and Password to get the default Wi-Fi SSID and
password.
5. Wait until the client device is connected to your device successfully.
Using a USB Cable
1. Connect a computer to your device with a USB cable.
2. Power on your device. The operating system detects and identifies new hardware, and automatically installs the
software.
3. Wait until the computer is connected to your device successfully.
Getting to Know the Wi-Fi SSID and Password
You can view the label on the device to get the default Wi-Fi SSID and password.
Logging in to the 4G Mobile Hotspot Configuration Page
1. Ensure that the connection between your device and the client device is correct.
2. Launch the Internet browser and enter http://192.168.0.1 or http://ufi.ztedevice.com in the address bar.
3. Enter the password to log in to the 4G Mobile Hotspot configuration page.
NOTE:
View the label on the device to get the default password.
Changing the Wi-Fi SSID or Password
1. Log in to the 4G Mobile Hotspot configuration page.
2. Select Wi-Fi Settings.
3. Change the Network Name (SSID) or the Password in the Main SSID area.
4. Click Apply.
Accessing the Internet
After a client device is successfully connected to your device, you can access the Internet in Automatic or Manual
mode. The default mode is Automatic.
To Next Page
Loading...
Need help?
General
