121
• Mode:
X Source: Turn on HDMI or Miracast as the projection
source.
X LABB: Enable or disable the Local Area Brightness
Boost feature or adjust its level. The projector can
adaptively gain up regions of an image that are dim
relative to the average picture level.
X CAIC: Enable or disable the Content-Adaptive
Illumination Control feature. The projector can
automatically adjust illumination power to consume less
battery while maintaining constant image brightness.
• Control:
X Projector: Turn on or off the projector.
X Gesture switch: After this feature is enabled, you can
swipe up or down using THREE fingers on the screen to
turn on or off the projector when Spro2’s screen is
turned on.
X Remote controller: Enable this feature before using the
remote control app in your Android phone to control
Spro 2. See Remote Control.
X Eye protection: This feature allows Spro2 to lower
projection brightness automatically when Spro2 detects
its own quick movement.
X Auto Projector: You can enable Spro2 to turn on or off
the projector automatically at the time you set.
X Restore: Restore default projector settings.
To Next Page
Loading...
