127
Don’t take your device
apart.
Avoid contact with
liquids. Keep your
device dry.
Radio Frequency (RF) Energy
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the United
States.
During SAR testing, this device is set to transmit at its highest
certified power level in all tested frequency bands, and placed
in positions that simulate RF exposure in usage near the body
with the separation of 10 mm. Although the SAR is determined
at the highest certified power level, the actual SAR level of the
while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power
levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless base station
antenna, the lower the power output.
The exposure standard for wireless employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands.
To Next Page
Loading...
