48
Projecting a File Saved in Your USB
Device
You can project a file stored on the USB device such as a USB
flash drive or a portable hard drive.
1. Slide the status bar down to open the notification panel and
ensure that “Connect to USB stick” is highlighted.
2. Connect your USB device to Spro2 via the USB jack.
3. Touch the Home Key > APPS tab > File Manager.
4. Touch USB DEVICE to open the file you want to project.
5. Turn on the projector. See Turning On/Off the Projector.
NOTES:
• To disconnect the USB device from your Spro2, you should
open the notification panel and touch . After Spro2
To Next Page
Loading...
