Zte MU5001 - 2. Install the Battery

17
• When the device is operating, do not touch the metallic parts.
Failing to do so may cause burns.
• Use original accessories or accessories that are authorized.
Using any unauthorized accessories may affect the
performance of the device and violate the related national
regulations about telecom terminals.
• Avoid using the device near or inside metallic constructions or
establishments that can emit electromagnetic waves,
because signal reception may be affected.
• The device is not waterproof. Keep the device dry and store it
in a shady and cool place.
• Do not use the device immediately after a sudden
temperature change, because dew may be generated inside
and outside the device. Do not use it until it becomes dry.
• Handle the device carefully. Do not drop, bend or strike it.
Otherwise the device may be damaged.
• Only qualified personnel can dismantle and repair the device.
• A humidity between 5% and 95% are recommended.
• Do not connect the charger while using the device for a long
period. Failing to do so will trigger the protection mechanism
of the battery, and the battery will not be charged. If you want
to charge the battery, please reconnect the charger.
• Do not connect the charger while using the device for a long
period or use the device and battery in non-operating
temperature. Failing to do so will shorten battery life or cause
battery swelling or leakage. If the battery shows signs of
swelling or leakage, please stop use immediately.
Battery Safety
•
Using ZTE-unapproved or incompatible battery, charger or
power adapter may damage your device, shorten its lifespan
or cause a fire, explosion or other hazards.
• The recom
m
and the stor
a
temperature
charging ca
p
• Do not pla
c
equipment,
Keep the d
e
and direct
s
overheat an
d
• Please dis
c
charged. O
v
• Do not shor
t
heat and fir
e
• Do not thro
w
• Do not disa
s
can cause e
• When not u
s
the battery
device and
s
• If the batter
y
please sto
p
authorized
s
• Return the
w
designated
r
• There is a
replaced.
WARNIN
G
If the battery
contents insid
e
with plenty of
w
18
m
ended operating te
m
a
ge temperatures a
r
s can damage th
p
acity and lifespan o
f
c
e the device or th
e
such as microwave
e
vice and the batter
y
s
unlight. If not, the
d
cause explosion o
r
c
onnectthe charger
v
ercharging may sho
r
t
-circuit the battery,
e
.
w
the battery into a fi
r
s
semble, squeeze o
r
x
plosion or fire.
s
ing the battery for
a
about half then re
m
s
tore it in a cool dry
p
y
damages or shows
p
use immediately
s
ervice provider for r
e
w
orn-out battery to
r
ecycle place. Do no
t
risk of explosion if
G
!
is broken, you sh
o
e
. If they contaminat
e
w
ater and seek medi
c
m
peratures are 0 °C
r
e -20 °C to +45 °C.
e device and red
f
your device and ba
e
battery in or nea
r
ovens, stoves or
r
y
away from exces
s
device or the batt
r
fire.
when the battery
r
ten the battery life.
as this can cause e
r
e to avoid explosion
r
puncture the batter
y
a
long period, pleas
e
m
ove the battery fr
o
p
lace.
signs of swelling or
and contact ZTE
e
placement.
the provider or put
t
put it in household
w
the wrong battery
m
o
uld avoid contact
e
the skin, immedia
t
c
al help when neces
s
to 35 °C
Extreme
uce the
t
tery.
r
heating
r
adiators.
s
ive heat
ery may
is fully
xcessive
.
y
, as this
e
charge
o
m your
leakage,
or ZTE
it in the
w
aste.
m
odel is
with the
t
ely rinse
s
ary.
19
Limited Warranty
This warranty does not apply to defects or errors in the product
caused by:
i. Reasonable abrasion.
ii. End users’ failure to follow ZTE’s installation, operation or
maintenance instructions or procedures.
iii. End users’ mishandling, misuse, negligence, or improper
installation, disassembly, storage, servicing or operation of
the product.
iv. Modifications or repairs not provided by ZTE or a
ZTE-certified individual.
v. Power failures, surges, fire, flood, accidents, and actions of
third parties or other events outside ZTE’s reasonable
control.
vi. Usage of third-party products or usage in conjunction with
third-party products if such defects are due to the
combined usage.
vii. Any other cause beyond the range of normal usage
intended for the product.
End users have no right to reject or return the product, or
receive a refund for the product from ZTE under the
above-mentioned situations.
This warranty is end users’ sole remedy and ZTE’s sole liability
for defective or nonconforming items, and is in lieu of all other
warranties, expressed, implied or statutory, including but not
limited to the implied warranties of merchantability and fitness
for a particular purpose, unless otherwise required under the
mandatory provisions of the law.
Limitation of Liability
ZTE shall not be liable for any loss of profits or indirect, special,
20
incidental or consequential damages resulting from or arising
out of or in connection with using of this product, no matter
whether or not ZTE had been advised, knew or should have
known of the possibility of such damages, including, but not
limited to lost profits, interruption of business, cost of capital,
cost of substitute facilities or product, or any downtime cost.
Radio Frequency (RF) Exposure
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the United
States.
During SAR testing, this device is set to transmit at its highest
certified power level in all tested frequency bands, and placed in
positions that simulate RF exposure in usage against the head
with no separation, and near the body with the separation of 10
mm. Although the SAR is determined at the highest certified
power level, the actual SAR level of the while operating can be
well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only
the power required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the power
output.
The exposure standard for wireless employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg.