Zte ZXV10 W300 - Page 19

F I G U R E 3 A D S L U P L I N K C O N N E C T I O N S
If a telephone needs to be installed in front of the splitter, the user must
connect a voice filter in the Line port of the splitter; then connect the ph
one to the splitter’s Phone port. The other port connections can be referr
ed to Figure 3.
A splitter consists of three ports:
 Line: The port connected to the ADSL subscriber line.
 Modem: The port connected to the W300’s LINE port.
 Phone: The port connected to a phone.
 Ethernet uplink
Port connections for Ethernet uplink mode can be referred to Figure 4. C
onnect one end of the RJ-45 Ethernet cable to the W300’s LAN1 port, an
d another end to the ISP’s network.
Proprietary Information of ZTE CORPORATION 8