Chapter 10 Home Networking
AX/DX/EX/PX Series User’s Guide
287
Note: You must configure a Bridge WAN interface in advance.
As APAS allows incoming traffic from any port to access any service on a configured LAN device, it may
be difficult to distinguish between appropriate and malicious traffic going to the LAN device. Make sure
to properly configure firewall rules to protect the LAN device, and monitor network traffic for suspicious
activity.
Click Network Setting > Home Networking > APAS to open this screen.
Network Setting > Home Networking > APAS
The following table describes the labels in this screen.
Table 77 Network Setting > Home Networking > APAS
LABEL DESCRIPTION
Enable Click Enable to activate APAS.
Add new MAC Rule Click this button to add a new MAC rule. You can create up to eight MAC rules.
# This is the index number.
Name This is the name of the rule.
MAC Rule This is the LAN host MAC address that is applied to the rule.
WAN Interface This is the bridge WAN interface for incoming traffic.
Cancel Click Cancel to restore your previously saved changes.
OK Click OK to save your changes.
To Next Page
Loading...
