ZyXEL Communications Dimension GS-3012 - Page 138

Chapter 40 OSPF Commands
Ethernet Switch CLI Reference Guide
138
ip ospf cost <1-65535> Sets the OSPF cost in this routing domain. C 13
no ip ospf cost <1-65535> Resets the OSPF cost in the routing
domain to default.
C13
ip ospf message-digest-key <key> Sets the OSPF authentication key in this
routing domain.
C13
no ip ospf message-digest-key <key> Disables the routing domain from using a
security key in OSPF.
C13
ip ospf priority <0-255> Sets the OSPF priority for the interface.
Setting this value to 0 means that this
router will not participate in router elections.
C13
no ip ospf priority <0-255> Resets the OSPF priority for the interface. C 13
router ospf <router-id> Enables and enters the OSPF
configuration mode.
C13
area <area-id> Enables and sets the area ID. C 13
no area <area-id> Removes the specified area. C 13
area <area-id> authentication Enables simple authentication for the area. C 13
area <area-id> authentication message-
digest
Enables MD5 authentication for the area. C 13
no area <area-id> authentication Sets the area to use no authentication
(None).
C13
area <area-iD> default-cost <0-16777214> Sets the cost to the area. C 13
no area <area-id> default-cost Sets the area to use the default cost (15). C 13
area <area-id> name <name> Sets a descriptive name for the area for
identification purposes.
C13
area <area-id> stub Enables and sets the area as a stub area. C 13
no area <area-id> stub Disables stub network settings in the area. C 13
area <area-id> stub no-summary Sets the stub area not to send any LSA
(Link State Advertisement).
C13
no area <area-id> stub no-summary Sets the area to send LSAs (Link State
Advertisements).
C13
area <area-id> virtual-link <router-id> Sets the virtual link ID information for the
area.
C13
no area <area-id> virtual-link <router-
id>
Deletes the virtual link from the area. C 13
area <area-id> virtual-link <router-id>
authentication-key <key>
Enables simple authentication and sets the
authentication key for the specified virtual
link in the area.
C13
no area <area-id> virtual-link <router-
id> authentication-key
Resets the authentication settings on this
virtual link.
C13
area <area-id> virtual-link <router-ID>
authentication-same-as-area
Sets the virtual link to use the same
authentication method as the area.
C13
no area <area-id> virtual-link <router-
id> authentication-same-as-area
Resets the authentication settings on this
virtual area.
C13
Table 92 OSPF Command Summary (continued)
COMMAND DESCRIPTION M P