EMG6726/8726-B10A User’s Guide
126
CHAPTER 9
Routing
9.1 Overview
The EMG usually uses the default gateway to route outbound traffic from computers on the LAN to the
Internet. To have the EMG send data to devices not reachable through the default gateway, use static
routes.
For example, the next figure shows a computer (A) connected to the EMG’s LAN interface. The EMG
routes most traffic from A to the Internet through the EMG’s default gateway (R1). You create one static
route to connect to services offered by your ISP behind router R2. You create another static route to
communicate with a separate network behind a router R3 connected to the LAN.
Figure 73 Example of Routing Topology
9.2 The Routing Screen
Use this screen to view and configure the static route rules on the EMG. Click Network Setting > Routing >
Static Route to open the following screen.
To Next Page
Loading...
