ZyXEL Communications GS1900-24 - The LACP Port Edit Screen

Chapter 22 Configuration: Link Aggregation
GS1900 Series User’s Guide
149
The following table describes the labels in this screen.
22.2.7 The LAC P Po rt Edit Sc re e n
Use this screen to edit a LACP Port. Click Co nfig ura tio n > Link Ag g re g a tio n > LA C P Po rt > Ed it to open this
screen.
Fig ure 150 Configuration > Link Aggregation > LACP Port > Edit
The following table describes the labels in this screen.
Table 96 Configuration > Link Aggregation > LACP Port
LABEL DESCRIPTIO N
LACP Port
Port Displays the port index number.
Priority Displays the priority value.
Timer (sec) Displays the Timer value in seconds.
Timeout is the time interval between the individual port exchanges of LACP packets in order to
check that the peer port in the trunk group is still up. If a port does not respond after three tries,
then it is deemed to be “down” and is removed from the trunk. Set a short timeout (one
second) for busy trunked links to ensure that disabled ports are removed from the trunk group as
soon as possible.
Edit Select this check box to configure the properties of a port. Click the Edit button change the
properties of the port.
Cancel Click C a nc e l to discard the changes.
Table 97 Configuration > Link Aggregation > LACP Port > Edit
LABEL DESCRIPTIO N
LACP Port
Port List Displays the list of port index numbers to be configured.
Priority Enter a value for the port priority. The number can be between 1 and 65,535.
Timer Select a timer value of either 1 second or 30 seconds.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.