Chapter 32 Configuration: Management
GS1900 Series User’s Guide
221
32.3.7 The Use r Add Sc re e n
Use this screen to configure the Use r settings. Click C o nfig ura tio n > Ma na g e m e nt > SNMP > Use r > Add to
open this screen.
Fig ure 225 Configuration > Management > SNMP > User > Add
The following table describes the labels in this screen.
32.3.8 The Tra p Sc re e n
Use this screen to configure the Tra p settings. Click Config ura tion > Ma na g e m e nt > SNMP > Tra p to open
this screen.
Table 173 Configuration > Management > SNMP > User > Add
LABEL DESCRIPTIO N
SNMP User
User Name Enter a string identifying the user name that this entry belongs to. The allowed string length is 1 to
30, and the allowed content is ASCII characters from 33 to 126.
Group Name Enter a string identifying the group name that this entry belongs to. The allowed string length is 1
to 30, and the allowed content is ASCII characters from 33 to 126.
Auth Protocol Select the authentication protocol that this entry belongs to. Possible authentication protocols
are:
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means you
must first ensure that the value is set correctly.
Auth Password Enter a string identifying the authentication password phrase. For MD5 authentication protocol,
the allowed string length is 8 to 32. For SHA authentication protocol, the allowed string length is
8 to 32. The allowed content is ASCII characters from 33 to 126.
Priv Password Enter a string identifying the privacy password phrase. The allowed string length is 8 to 64 and
the allowed content is ASCII characters from 33 to 126.
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
To Next Page
Loading...
