ZyXEL Communications GS1900-24 - The User Screen

Chapter 32 Configuration: Management
GS1900 Series User’s Guide
220
32.3.6 The Use r Sc re e n
Use this screen to view the Use r settings. Click C o nfig ura tion > Ma na g e m e nt > SNMP > Use r to open this
screen.
Fig ure 224 Configuration > Management > SNMP > User
The following table describes the labels in this screen.
Security Level Select the security model that this entry belongs to. Possible security models are:
• no a uth: No authentication and no privacy.
• a uth: Authentication and no privacy.
• priv: Authentication and privacy.
Access Mode Select the access mode for this entry. The possible values are Re a d - O nly and Re a d - Write .
Apply Click A pp ly to save the changes.
Cancel Click C a nc e l to discard the changes.
Table 171 Configuration > Management > SNMP > Group > Add (continued)
LABEL DESCRIPTIO N
Table 172 Configuration > Management > SNMP > User
LABEL DESCRIPTIO N
SNMP User
User Name Displays a string identifying the user name that this entry belongs to. The allowed string length is
1 to 30, and the allowed content is ASCII characters from 33 to 126.
Group Displays a string identifying the group name that this entry belongs to. The allowed string length
is 1 to 30, and the allowed content is ASCII characters from 33 to 126.
Privilege Mode Displays the privilege mode that this entry belongs to.
Authentication
Protocol
Displays the authentication protocol that this entry belongs to. Possible authentication protocols
are:
• No ne : No authentication protocol.
• MD5: An optional flag to indicate that this user uses MD5 authentication protocol.
• SHA: An optional flag to indicate that this user uses SHA authentication protocol.
The value of the security level cannot be modified if the entry already exists. That means you
must first ensure that the value is set correctly.
Encryption
Protocol
Displays the encryption protocol that this entry belongs to.
Access Right Displays the access mode for this entry. The possible values are Re a d - O nly and Re a d- Write .
Action
Delete Click De le te to remove the entry.
Add Click Add to create a new SNMP user.