GS2210 Series User’s Guide
362
CHAPTER 43
Access Control
43.1 Access Control Overview
This chapter describes how to control access to the Switch.
A console port and FTP are allowed one session each, Telnet and SSH share nine sessions, up to five
Web sessions (five different user names and passwords) and/or limitless SNMP access control
sessions are allowed.
A console port access control session and Telnet access control session cannot coexist when multi-
login is disabled. See the CLI Reference Guide for more information on disabling multi-login.
43.1.1 What You Can Do
•Use the Access Control screen (Section 43.2 on page 362) to display the main screen.
•Use the SNMP screen (Section 43.3 on page 363) to configure your SNMP settings.
•Use the Trap Group screen (Section 43.3.1 on page 364) to specify the types of SNMP traps that
should be sent to each SNMP manager.
•Use the User Information screen (Section 43.3.3 on page 366) to create SNMP users for
authentication with managers using SNMP v3 and associate them to SNMP groups.
•Use the Logins screens (Section 43.4 on page 368) to assign which users can access the Switch
via web configurator at any one time.
•Use the Service Access Control screen (Section 43.5 on page 369) to decide what services you
may use to access the Switch.
•Use the Remote Management screen (Section 43.6 on page 370) to specify a group of one or
more “trusted computers” from which an administrator may use a service to manage the Switch.
43.2 The Access Control Main Screen
Use this screen to display the main screen.
Click Management > Access Control in the navigation panel to display the main screen as
shown.
Table 180 Access Control Overview
Console Port SSH Telnet FTP Web SNMP
One session Share up to nine sessions One session Up to five accounts No limit
To Next Page
Loading...
