Chapter 5 Initial Setup Example
GS2210 Series User’s Guide
45
1 Connect your computer to any Ethernet port on the Switch. Make sure your computer is in the same
subnet as the Switch.
2 Open your web browser and enter 192.168.1.1 (the default IP address) in the address bar to access
the web configurator. See Section 4.2 on page 34 for more information.
3 Click Basic Setting > IP Setup in the
navigation panel.
4 Configure the related fields in the IP Setup
screen.
5 For the VLAN2 network, enter 192.168.2.1 as
the IP address and 255.255.255.0 as the
subnet mask.
6 In the VID field, enter the ID of the VLAN group
to which you want this management IP address
to belong. This is the same as the VLAN ID you
configure in the Static VLAN screen.
7 Click Add to save your changes back to the run-
time memory. Settings in the run-time memory
are lost when the Switch’s power is turned off.
To Next Page
Loading...
