ZyXEL Communications NAS542 - Configure General TCP;IP Settings; TCP;IP Screens

Chapter 8 Control Panel: Network
NAS Series User’s Guide
130
8.4 TCP/IP Screens
Use the TCP/IP screens to have the NAS use a dynamic or static IP address, to configure its subnet mask,
default gateway, PPPoE and DNS servers, and to test the network connection.
8.4.1 Configure General TCP/IP Settings
Click Control Panel > Network > TCP/IP > General Settings in the navigation panel to open the following
screen. This screen allows you to configure the default gateway and DNS server.
Note: If you change the NAS’s IP address, you need to log in again after you apply changes.
Figure 99 Control Panel > Network > TCP/IP > General Settings
The following table describes the labels in this screen
Table 74 Control Panel > Network > TCP/IP > General Settings
LABEL DESCRIPTION
Default Gateway Select the LAN interface to use as the default gateway.
DNS Server DNS (Domain Name System) is for mapping a domain name to its corresponding IP address
and vice versa. If you have the IP address(es) of the DNS server(s), enter them.
Automatically Select the option to have the NAS get a DNS server address automatically.
Manually Select this option to choose a static DNS server address. Type the DNS server IP address(es)
into the fields below.
Primary DNS
Server
Type a primary DNS server IP address.
Secondary DNS
Server
Type a secondary DNS server IP address.