Chapter 8 Control Panel: Network
NAS Series User’s Guide
144
Note: The default of the WAN port for the newly created service displays -1. Specify the port
number from 1 to 65,535, or you cannot access that service from the Internet.
8.6 Terminal Screen
Use this screen to enable or disable Telnet and SSH (Secure SHell) access to the NAS.
Telnet or SSH access lets you use line commands to configure the NAS. Use these commands at your
own risk. The vendor takes no responsibility for any changes you make using the commands.
Click Control Panel > Network > Terminal in the navigation panel to open the following screen.
To Next Page
Loading...
