Chapter 11 Control Panel: Maintenance
NAS Series User’s Guide
183
• Use the Syslog Server Setting screen (Section 11.4.4 on page 184) to enable the syslog server and
select the categories to include in the log report.
11.4.2 Email Setting
You can enable and configure e-mail alerts from the NAS. In the Log Report Configuration screen, click
the Email Setting tab to open the following screen.
Figure 148 Control Panel > Service > Maintenance > Log > Report Config: Email Setting
The following table describes the labels in this screen.
Table 108 Control Panel > Service > Maintenance > Log > Report Config: Email Setting
LABEL DESCRIPTION
Enable Log Email Click this to have the NAS e-mail log alerts to your e-mail account.
Email To Enter the e-mail address where you want to receive the log alerts.
Email From Enter the e-mail address the NAS uses in the From field of the e-mail header for its log alerts.
Email Server Enter the e-mail server address the NAS uses to send e-mail alerts,
Email Format Select the e-mail format you want the NAS to use in its e-mail alerts.
Use SMTP
Authentication
Click this if the e-mail server you want the NAS to use for its e-mail alerts requires a username
and password.
User Enter the username for the e-mail server.
Password Enter the password for the e-mail server.
Password
(Confirm)
Re-enter the password to confirm it.
After apply settings,
send a test email
Click this to have the NAS send a test e-mail to the settings you have entered.
Apply Click this to save your changes.
Cancel Click this to return to the previous screen without saving.
To Next Page
Loading...
