Chapter 10 Routing
NR/FWA Indoor Series User’s Guide
175
10.3.1 Add or Edit DNS Route
You can manually add the Zyxel Device’s DNS route entry. Click Add New DNS Route in the DNS Route
screen, use this screen to configure the required information for a DNS route.
Figure 107 Network Setting > Routing > DNS Route > Add New DNS Route
The following table describes the labels in this screen.
10.4 Policy Route
By default, the Zyxel Device routes packets based on the shortest path to the destination address. Policy
routes allow you to override the default behavior and route packets based on other criteria, such as the
WAN Interface This is the WAN interface through which the matched DNS request is routed.
Subnet Mask This parameter specifies the IP network subnet mask.
Modify Click the Edit icon to configure a DNS route on the Zyxel Device.
Click the Delete icon to remove a DNS route from the Zyxel Device.
Table 55 Network Setting > Routing > DNS Route (continued)
LABEL DESCRIPTION
Table 56 Network Setting > Routing > DNS Route > Add New DNS Route
LABEL DESCRIPTION
Active Enable DNS route in your Zyxel Device.
Domain Name Enter the domain name you want to resolve. Up to 64 printable ASCII characters are allowed
except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ].
You can use the wildcard character, an “*” (asterisk) as the left most part of a domain name,
such as *.example.com. The Zyxel Device forwards DNS queries for any domain name ending in
example.com to the WAN interface specified in this route.
Subnet Mask Enter the subnet mask of the network for which to use the DNS route in dotted decimal
notation, for example 255.255.255.255.
WAN Interface Select a WAN interface through which the matched DNS query is sent. You must have the WAN
interfaces already configured in the Broadband screen.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving.
To Next Page
Loading...
