Chapter 2 Hardware
NR/FWA Indoor Series User’s Guide
34
Turning on WiFi
Press the WiFi/WPS button on the Zyxel Device and then release it.
After WiFi is turned on, the LED lights green.
Activating WPS
You can also quickly set up a secure WiFi connection between the Zyxel Device and a WPS-compatible
client by adding one device at a time.
1 Ensure WiFi is turned on.
2 Press the WiFi/WPS button and release it to enable WPS.
3 Press the WPS button on another WPS-enabled device that is within range of the Zyxel Device within 120
seconds.
After a WiFi connection is established, the WiFi/WPS LED blinks slowly green.
2.5.2 NR5103/NR5103E/FWA510 WiFi/WPS Button
The following figure shows the WiFi/WPS button on the Zyxel Device.
Figure 23 NR5103/NR5103E/FWA510 WiFi/WPS Button
Activating WPS
You can also quickly set up a secure WiFi connection between the Zyxel Device and a WPS-compatible
client by adding one device at a time.
1 Ensure WiFi is turned on.
2 Press the WiFi/WPS button and release it to enable WPS.
To Next Page
Loading...
