Chapter 29 Remote Management
NR/FWA Indoor Series User’s Guide
296
The following table describes the fields in this screen.
29.5 Trust Domain for IP Passthrough
Use this screen to view a list of public IP addresses/complete domain names which are allowed to
access the Zyxel Device when IP Passthrough is enabled. IP Passthrough allows Internet traffic to go to a
LAN computer behind the Zyxel Device without going through NAT. Make sure to enable IP Passthrough
in Network Setting > Broadband > Cellular IP Passthrough.
Click Maintenance > Remote Management > Trust Domain for IP Passthrough to open the following
screen.
Figure 182 Maintenance > Remote Management > Trust Domain for IP Passthrough
The following table describes the fields in this screen.
Table 126 Maintenance > Remote Management
LABEL DESCRIPTION
Service This is the service you may use to access the Zyxel Device.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from all WAN connections.
Trust Domain Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the trusted host IP address.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.
Table 127 Maintenance > Remote Management > Trust Domain for IP Passthrough
LABEL DESCRIPTION
Add Trust Domain Click this to add a trusted host IP address.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trusted host IP address.
To Next Page
Loading...
