Chapter 7 Broadband
NR/FWA Indoor Series User’s Guide
113
7.8 Cellular Band Configuration
Either select Auto to have the Zyxel Device connect to an available network using the default settings
on the SIM card or select the type of the network (NR5G, 4G, 3G) to which you want the Zyxel Device to
connect.
Click Network Setting > Broadband > Cellular Band. The following screen opens.
Figure 60 Network Setting > Broadband > Cellular Band
The following table describes the fields in this screen.
7.9 Cellular PLMN Configuration
Each service provider has its own unique Public Land Mobile Network (PLMN) number. Either select PLMN
Auto Selection to have the Zyxel Device connect to the service provider using the default settings on the
SIM card, or manually view available PLMNs and select your service provider.
Click Network Setting > Broadband > Cellular PLMN. The screen appears as shown next.
Table 27 Network Setting > Broadband > Cellular Band
LABEL DESCRIPTION
Access Technology
Preferred Access
Technology
Select the cellular mode your Zyxel Device supports to which you want the Zyxel Device to
connect, and then click Apply to save your settings.
Otherwise, select Auto to have the Zyxel Device connect to an available network using the
default settings on the SIM card. If the currently registered mobile network is not available or
the mobile network’s signal strength is too low, the Zyxel Device switches to another
available mobile network.
Band Management
Band Auto Selection Select the cellular bands to use for the Zyxel Device’s cellular WAN connection. Click this
switch to enable automatic frequency band selection as provided by the cellular service
provider. Otherwise, select disabled.
Apply Click this to save your changes.
Cancel Click this to exit this screen without saving.
To Next Page
Loading...
