Chapter 8 Wireless
NR/FWA Indoor Series User’s Guide
135
Figure 78 Network Setting > Wireless > WLAN Scheduler > Add New Rule
The following table describes the labels in this screen.
8.9 Channel Status
Use this screen to scan for WiFi channel noise and view the results. Click Scan to start, and then view the
results in the Channel Scan Result section. The value on each channel number indicates the number of
Access Points (AP) using that channel. The Auto-channel-selection algorithm does not always directly
follow the AP count; other factors about the channels are also considered. Click Network Setting >
Wireless > Channel Status. The screen appears as shown.
Table 43 Network Setting > Wireless > WLAN Schedule > Add New Rule
LABEL DESCRIPTION
Active Click this switch to enable this WLAN scheduler rule.
SSID Select All wireless networks if you want the rule to apply to all wireless network interfaces or
select a wireless network interface to apply the rule to.
Rule Name Enter a descriptive name for the rule.
Day Select the days of the week that you wish to apply this rule.
Time of Day Range Specify the time of the day that you wish to apply to this rule (format hh:mm).
Note: Click the check box for All days if you wish to apply the rule for the whole day
(24 hours).
Description Enter a description of the rule, usually to help identify it (its purpose).
OK Click OK to save the changes back to the Zyxel Device.
Cancel Click Cancel to close the window with changes unsaved.
To Next Page
Loading...
