ZyXEL Communications NR5103 - Easymesh; Technical Reference; Wifi Network Overview

Chapter 8 Wireless
NR/FWA Indoor Series User’s Guide
137
8.10 EasyMesh
Use this screen to enable or disable EasyMesh Controller on the Zyxel Device. Click Network >Wireless>
EasyMesh to open the following screen.
Figure 80 Network > Wireless > EasyMesh
The following table describes the labels in this screen.
8.11 Technical Reference
This section discusses WiFi in depth.
8.11.1 WiFi Network Overview
WiFi networks consist of WiFi clients, access points and bridges.
• A WiFi client is a radio connected to a user’s computer.
• An access point is a radio with a wired connection to a network, which can connect with numerous
WiFi clients and let them access the network.
• A bridge is a radio that relays communications between access points and WiFi clients, extending a
network’s range.
Normally, a WiFi network operates in an “infrastructure” type of network. An “infrastructure” type of
network has one or more access points and one or more WiFi clients. The WiFi clients connect to the
access points.
Table 45 Network Setting > Wireless > EasyMesh
LABEL DESCRIPTION
EasyMesh
Controller
Slide the switch to the right ( )to enable EasyMesh Controller.
On-Boarding To enable WPS, click the Trigger button until the WPS LED blink green. Press the WPS button on
the client device within 150 seconds.
OK Click OK to save the changes back to the Zyxel Device.
Cancel Click Cancel to close the window with changes unsaved.