Chapter 2 Hardware
NR/FWA Indoor Series User’s Guide
32
Figure 21 NR5103/NR5103E/FWA510 Ports and Buttons
The following table describes the ports and buttons on the Zyxel Device.
Table 8 NR5103/NR5103E/FWA510 Ports and Buttons
LABELS DESCRIPTION
ANT1-ANT2/Antenna Install the external antennas to strengthen the cellular signal.
Note: To use the external antennas, you must set the INT/EXT switch to EXT.
USB The USB port of the Zyxel Device is used for file sharing.
LAN2/WAN LAN mode: Connect a computer to the LAN using an RJ45 cable.
WAN mode: Connect the Zyxel Device to the Internet through the WAN.
LAN1 Connect a computer to the LAN using an RJ45 cable.
WiFi/WPS Press the WiFi/WPS button to activate WPS connection process. See Table 9 on page 33
for more information.
RESET Press the RESET button to reboot or reset the Zyxel Device. See Table 10 on page 35 for
more information.
ON/OFF Press the ON/OFF button after the power adapter is connected to start the Zyxel
Device.
To Next Page
Loading...
