ZyXEL Communications Q1000z - Set Up a WPS Connection; Wall-mounting

8
Set Up a WPS Connection
Press the WPS button on the Q1000Z’s front panel for more than 5
seconds to turn the WPS function on.
Follow these steps to add a WPS-enabled device to the wireless network
using the WPS button.
Wall-mounting
Take the following steps to hang your Q1000Z on a wall.
1. Select a position free of obstructions on a sturdy wall.
2. Drill two holes for the screws, exactly 110 mm apart.
Place the devices you want to connect
near one another.
Press the WPS button on the Q1000Z.
The WPS light blinks.
Press the WPS button on a compatible
device within 2 minutes of pressing the
button on the Q1000Z.
The WPS light on the Q1000Z shines
steadily when connected.
1
2
3