UAG CLI Reference Guide 191
CHAPTER 30
SSL Application
This chapter describes how to configure SSL application objects for use in SSL VPN.
30.1 SSL Application Overview
Configure an SSL application object to specify a service and a corresponding IP address of the
server on the local network. You can apply one or more SSL application objects in the VPN > SSL
VPN screen for a user account/user group.
30.1.1 SSL Application Object Commands
This table lists the commands for creating SSL application objects. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
Table 109 SSL Application Object Commands
COMMAND DESCRIPTION
show sslvpn application
[application_object]
Displays SSL VPN application objects.
[no] sslvpn application
application_object
Enters the sub-command mode to create an SSL VPN application object.
server-type rdp server-address
server-address [starting-
port <1..65535> ending-port
<1..65535>] [program-path
program-path]
Creates an SSL application object to allow users to manage LAN computers
that have Remote Desktop Protocol remote desktop server software
installed.
Specify the listening ports of the LAN computer(s) running remote desktop
server software. The UAG uses a port number from this range to send traffic
to the LAN computer that is being remotely managed.
program-path: specify an application to open when a remote user logs into
the remote desktop application, for example, C:\Program
Files\application\application.exe.
server-type vnc server-address
server-address [starting-
port <1..65535> ending-port
<1..65535>]
Creates an SSL application object to allow users to manage LAN computers
that have Virtual Network Computing remote desktop server software
installed.
Specify the listening ports of the LAN computer(s) running remote desktop
server software. The UAG uses a port number from this range to send traffic
to the LAN computer that is being remotely managed.
To Next Page
Loading...
